Shopping Cart
The Vaporesso 0.4 ohm XROS Pro Cartridge essentials in 10 seconds
- Mod-Style Clouds: Unlike classic XROS pods designed for mouth-to-lung hits, this 0.4-ohm tank is engineered for direct inhalation. It generates vapor akin to a traditional 30W clearomizer.
- Integrated COREX 2.0: Vaporesso has improved the mesh structure and fine-tuned the Cumulus cotton. This ensures that the intense heat generated by the 0.4 ohms does not burn the coil prematurely, radically extending its lifespan.
- Total Anti-Leak Tech: Despite vaporizing enormous amounts of e-liquid per second, the SSS system perfectly seals the tank to keep your device's battery housing free of moisture and drips.
Vital Compatibility Restrictions
WARNING: Due to the massive energy requirement of 0.4 ohms, this cartridge will ONLY work safely and efficiently on XROS devices capable of delivering output above 25W. Its optimal use is designed for:
- Vaporesso XROS Pro (The native device to fully utilize its 30W).
- Vaporesso XROS 4 and XROS 4 Mini.
- Vaporesso XROS 3 (Full-size version, though battery may drain quickly).
- * Under no circumstances is it recommended for older XROS devices or 1st/2nd generation Nano/Mini versions.
Squeezing the flavor at 30 Watts
By opting for the 0.4 ohm pod, you enter the major league of juices and flavor:
- Recommended Liquids: This coil is a "juice devourer." It works perfectly with dense High VG blends (70VG/30PG). Using thin 50/50 liquids could lead to excessive heat and unwanted spitback.
- Flavor Profiles: Excellent for extracting maximum sweetness from desserts and highlighting the icy kick in fresh fruity blends.
- Forbidden for Salts: Under absolutely no circumstances should you use Nicotine Salts with this pod. The ultra-high vaporization rate will cause a brutal throat hit and rapid discomfort from nicotine overdose.
Frequently Asked Questions about 0.4 XROS Cartridges
The 3ml tank is filled from the top, how does that work?
Exactly. Vaporesso achieved the impossible: an XL 3ml tank featuring "Top Fill". Just snap the cartridge into your XROS Pro battery, place your thumb flat against the black mouthpiece, and push firmly to the side. The cap will pop off, revealing the red silicone top-fill membrane.
I put it in my old XROS 2 and the vapor is cold and weak, is it broken?
No, the coil is not broken. The XROS 2 does not have an electronic board capable of sending the explosive power required by a wire as thick as this 0.4-ohm mesh. To notice the intense flavor and generate clouds, you need to install it in a modern XROS mod that delivers close to 30W.
