It is important that you become familiar with your new electronic cigarette and your vaping equipment before using it for the first time.
Fill the tank with your e-liquid. To fill the tank do it slowly, pouring the liquid through the wall of the same, to prevent liquid from falling into the central pole of the clearomizer; In this way, you will avoid puddling the resistance and the liquid dripping to the outside.
If the resistance is new, throw 3-4 drops of liquid inside. Then place it again and fill the clearomizer to the maximum line and let it rest for a few minutes so that the liquid soaks the cotton of the coil. A good idea is to take several puffs without pressing the button to make sure that the liquid drains perfectly into the head coil. If you start vaping with dry cotton, you will burn the resistance cotton and it will be unusable.
Next, turn on the battery (usually with 5 clicks followed by the button) to check if it is charged. If it does not light, put it to charge with the supplied cable until it is fully charged.
Be especially careful with threads. Generally, to force the threads or to tighten them in excess, produces that it ends up damaging the equipment leaving it unusable.
Take the mouthpiece of the vaper to the mouth, press the button and simultaneously inhale extensively. Do not use the electronic cigarette like a traditional cigar: vape with calm, with slow and prolonged puffs and you will obtain a dense vapor and a good flavor. You can also try to give stronger puffs by directly sucking lung, vapers find it much more satisfying than vaping to "mouth".
If no steam occurs, check that the battery is on (it should light up when the button is pressed). There are times when the equipment does not detect the resistance and when the button is pressed the light flashes and it does not work. This may be because the base of the resistor does not make proper contact with the battery. To facilitate contact, simply pinch lightly and remove half a millimeter the metal pin (the metal part that is surrounded by a rubber) in the lower part of the resistance. Then you have to rethread the resistance to the equipment by tightening the thread well.
It may also be that the resistance has been burned, so the solution is to replace it with a new one.
When the battery flashes multiple times it is exhausted. Reload it for a few hours.
Although it is usual to read recommendations that recommend charging the battery completely for a few hours before using it for the first time, we do not recommend it unless it is discharged. The batteries of our electronic cigarettes are Lithium-Ion so they have no memory effect like their NI-MH predecessors. What really shortens the life of the batteries is to discharge them and / or charge them in excess. To avoid these two situations, they are provided with a circuit that disconnects them when they are fully charged or discharged, when a short circuit occurs, or when the power button is pressed for more than 10 seconds.
Fill the tank up to the maximum line and let it rest for a few minutes, so that the liquid soaks the cotton. You can also take a few puffs without pressing the button so that the liquid drains into the coil and soaks the cotton. This only needs to be done when we launch a new coil.
To fill the tank do it slowly, pouring the eliquid on the side, to prevent liquid from falling into the central pole of the clearomizer, in this way we will avoid puddling the coil and the liquid dripping to the outside.
Take special care with the threads, generally, force the threads or tighten them excessively, causing leakage of the liquid from the claromizer leaving it unusable.
When there is little liquid in the tank, it is convenient to recharge it, you should never vape with the empty tank because we will obtain unpleasant flavors and the resistance cotton will be burned.
To transport your electronic cigarette it is convenient to turn it off to avoid accidental pulsations of the puff button.
If you are going to carry your electronic cigarette in your trouser pocket, be careful to avoid that when you sit down it may break or get loose.
The e-cigs are electronic devices, treat them with care. Shocks, water and lack of cleaning will shorten its life.
It is advisable to regularly clean the electrical connections, threads and nozzles. Due to steam condensation or small leaks from the air inlets, it is common for there to be liquid in the threads or in the drip tips. A paper handkerchief or a piece of kitchen paper is ideal.
If we observe frequent leakage , it is necessary disassemble , clean thoroughly, check all gaskets, and reassemble . If the problem persists, change the head is removable if changes or discard the gaskets claromizador.
Occasionally recommend a thorough cleaning of atomizers clariconos and washing with warm water and soaking them in vodka and let them dry a few hours later. Never use other beverages containing sugar or pure alcohol.