Prebuilt Chernobyl Coils NUCLEAR RAM 0.12Ohm (Pack 2) by Charro Coils
Discover the Prebuilt Chernobyl Coils NUCLEAR RAM of 0.12Ohm by Charro Coils, handcrafted using top-quality Nichrome 80. With an inner diameter of 2.25 mm and versatile resistance value, these are perfect for a superior vaping experience. Purchase now and feel the excellence of these coils made in Spain!
Available for immediate delivery
Warning: Last items in stock!
By buying this product you can collect up to 1 loyalty point. Your cart will total 1 point that can be converted into a voucher of 0,10 €.
Prebuilt Chernobyl Coils NUCLEAR RAM 0.12Ohm (Pack 2)
0.12 ohm/dual coil - 0.24 ohm/single coil
by Charro Coils
Chernobyl Coils is a new brand of artisanal coils from the creators Charro Coils.
NUCLEAR RAM 0.12Ohm, designed for dual coil with immediate response.
They work perfectly with almost all atomizers from drippers to tanks.
*Pack 2 units
* Important tips for repairable coils:
When you unpack the coil, place it on a guide of the indicated diameter, insert the legs of the coil into the hole of the atomizer deck, one leg on the positive pole and another on the negative pole.
Adjust the position of the coil in place and tighten the screws, finally, cut the excess.
Once installed make sure that it does not touch the coil with any metal part of the atomizer to avoid short circuits.
When we have them installed, we will proceed to stabilize it. This process has to be carried out in an electronic device, never in a mechanical mod. To start stabilizing the coils, select a low power output voltage in the electronic device, around 1.8V. Little by little we will give short presses until we see that the coil is picking up temperature. Without ever putting the coil completely incandescent, we will glimpse, a series of points that light up more than the rest of the coil. To eliminate these points and that the coil is properly stabilized, we will tighten the turns of the coil with ceramic tweezers, gently and slowly until they have been completely removed.
When we see that the coil is dirty or that the cotton has lost some of its properties, we will remove the cotton and repeat the process of stabilizing the coils, but in a much softer way, never turning them red hot. We will heat them calmly and before they become incandescent we will clean them with a metal brush, we will repeat this process two or three times in each cleaning, when they are already clean of the largest remains, we will reheat them and submerge them hot in a glass of water to temper them and that there is a cleaning in the coil by pyrolysis until it is perfectly clean.
Then, we will put the cotton and the liquid back.
The duration of the coils depends largely on the proper maintenance and aggressiveness of the liquids we use when vaping.
All coils work perfectly in both electronic mods and mechanical mods.
Electronic mods: You have to be always attentive in case you have been able to leak some liquid in the electronics, keep the mod clean and always use batteries with high discharge amperage and in good condition.
Mechanical mods: This is where more emphasis needs to be made on safety. It is essential that the mod is always clean, without bumps and with all the pieces that compose it correctly placed. When mechanical devices are used, ALWAYS use batteries with the maximum possible discharge amperage.